[Ashikabi]

Originally Posted by zeal86

I began the molding process with the bumper extention...I still have some tweaking, filler, glazing, and sanding to do.

So far so good.





Next up will be temp installing the rear bumper so I can block the union with the rear overfender. Almost ready to two-part epoxy the rear overfender!
@Ashikabi Btw, I'm thinking of cutting the side skirt at the front door gap and molding it to the front fender. This will allow for the fender to be removed if need be. I'd keep the gap between the two sections of the side skirt to 1/16th of an inch or so to keep the look seamless as possible.



IG @zeal.eightsix

Good call