|
(2) Canceling the system operation:
Make sure the following conditions are met:
The engine switch is off.
The driver side door is closed.
The driver side door is unlocked.
Press the unlock switch of the electrical key transmitter sub-assembly.
Open the driver side door within 5 seconds of completing the step above (driver side door: closed at beginning of step → opened).
With the driver side door open, press the unlock switch of the electrical key transmitter sub-assembly 2 times within 5 seconds of completing the step above.
NOTICE:
If the driver side door is closed before or while pressing the unlock switch, the entry cancel setting mode will end.
Close and open the driver door twice (driver door: open → closed → opened → closed → opened).
With the driver door open, press the unlock switch of the electrical key transmitter sub-assembly 2 times.
NOTICE:
If the driver side door is closed before or while pressing the unlock switch, the entry cancel setting mode will end.
Close and open the driver door (driver door: open → closed → opened).
Close the driver side door within 5 seconds of completing the above step.
Check that the wireless buzzer sounds twice (short beeps) to confirm that the smart key system has been canceled.
HINT:
Finish steps 5 to 7 within 30 seconds.
(3) Perform the following procedure to restore the smart key system to the active state from the canceled state.
Perform the procedures to cancel the smart key system again.
Check that the wireless buzzer sounds once (short beep) to confirm that the smart key system has been restored to the active state.
HINT:
The system changes between the canceled state and the active state each time the procedure to cancel the system is performed.
The buzzer sounds twice when the system changes from the active state to the canceled state, and sounds once when the system changes from the canceled state to the active state.
|