08-24-2018, 06:41 PM
|
#2862
|
|
sleep, drive, eat, repeat
Join Date: Mar 2012
Drives: '13 BRZ, '12 Outback
Location: Sack of Potatoes
Posts: 4,431
Thanks: 2,630
Thanked 3,797 Times in 1,981 Posts
Mentioned: 188 Post(s)
Tagged: 4 Thread(s)
|
Quote:
Originally Posted by shiumai
I had this happen just today. Sitting at a traffic light and upon taking off, CEL came on and car went into limp mode. Pulled over, then made it into a parking lot where I pulled out my OBD2 reader to pull the code.
I had noticed maybe 5 times over the past year that sometimes when I started the car, the idle would be a bit lower than normal, and the car stalled a couple of times. When I wiggled the Edelbrock throttle body connector, the idle went back to normal.
So when I pulled the P2135 code this morning, I did a search and came up with the above post. I wiggled the plug and cleared the code, and was able to drive into work. It seemed to act normally.
I'm hoping that it's just that harness plug related. I'm going to clean the connections and see what happens.
|
Are you still on the CARB tune when this happened? I've had this code pop-up twice. Once while on a modified CARB tune, where I did as I mentioned: unplugged and cleaned the connectors on the harness connecting to the throttle pedal and the throttle body. The second time I got this code was when I switched to the Delicious D-box, which happened immediately. This turned out to be a defective D-box, which I got replaced. Never had the code after that.
|
|
|