[gtpvette]

Finally got a few minutes to work on the car this weekend. The last 3-4 weeks have been maintenance on the boat,,, a lot of maintenance. That said,,, new aluminum PCM mount is done,, it bolts to the original one I did. As stated earlier, I had to move that radiator pipe swapping it out for one from a CTS. In the one picture you can see how it slopes down from the back of the motor to below the alternator.

You can also see in the picture the new water pipe is bent at a funny angle as related to the radiator output. I think if I cut it and rotate it a bit it'll be OK. Ordered a new 45 degree 1.75 to 1.25 silicone reducer so i'll hold off until that gets in.

Also had to rework the dip stick for the 12th time. Think I'm OK now.

Back to wiring.