Quote:
Originally Posted by rvoll
Since you spoke to them, what did they say about the 12v to 6v adapter? The other issue would be a manufacturing defect on the loom with a poor connection. There are lots of places where there could be a problem. You would need to take out the loom and use a continuity tester to test the connections. Sometimes pins inside the connectors can be pushed loose. If you are pushing 12v to a 6v device, there can also be damage to the device depending on the circuitry.
|
They said the camera should work and sent another cable in case the first one was bad. I don't think you were following my previous posts about what I'm looking for and what's been offered. And I don't think you are familiar with this setup from Carbon. We've eliminated the concerns about the fuse. I'm not sure I am getting back signal so there might be problem somewhere else besides the 12/6volt issue you are locked in on. Thanks for the help.