[djezlee]

Originally Posted by rvoll

You might want to look at this:

https://www.ft86club.com/forums/showthread.php?t=111866

Not only do you need a 12v to 6v converter, but you need to splice into the reverse wire. Did you do that? Was the unit spliced into the system or did you use an adapter? If you used an adapter, was it configured for the camera? The Kenwood uses a camera control terminal while the OEM camera does not. How did you connect the camera control terminal?

Unfortunately, there are no standards for the camera so each installation is custom. It is NOT just plug and play. The best solution would be to replace the OEM camera (which isn't that good anyway), with the Kenwood camera accessory. You'd have to run the wires through the car which would take some time to do, but it would work.

Good luck. I've installed several heads/cameras in my cars over the years, but have always purchased matched components and tried to find plug in adapters from people like Metra.

This link/thread doesn't talk about the Carbon adapter. https://carboncarsystems.com.au/shop...17-subaru-brz/