06-15-2018, 12:56 PM
|
#320
|
|
Senior Member
Join Date: Sep 2017
Drives: 2022 BRZ Limited Silver
Location: Jacksonville, FL
Posts: 2,533
Thanks: 883
Thanked 2,048 Times in 1,190 Posts
Mentioned: 68 Post(s)
Tagged: 0 Thread(s)
|
Quote:
Originally Posted by TheStig85
Typically if I clear the code, it just comes back in 2-3 cycles. Always P0016. Nothing else. Aside from car going into lump mode, it runs fine.
I cleared codes and monitored the VVT values. Everything looked like it was following the Target values. Was, also, monitoring as the CEL kicked in and I noticed all the guages just stopped displaying values. So maybe that one time I saw 'some' values with the CEL present wasn't accurate.
As per TechStream... I had in installed but whenever I went to look at the Data List, the program would crash. Do you by chance have the program that I could install? If not, I'll try to contact the buyer again. Just difficult to communicate with them due to time zone (China).
|
Check your PM's.
|
|
|