|
What I did, was remove the cover, took a sheet of paper, and cut a hole in it, the diameter of the shaft. Inserted shaft thru paper, and then into the car. Hold the paper taught to the bumper, and rubbed the edges with a pencil, to leave an outline.
Now you have a pattern, to locate the hole.
For the bigger geeks, I then scanned the outline, brought it into my CAD software, and copied the cover shape, and put a center mark on the hole. Printed it, placed it over the cover, and drilled.
Note, I managed to use the words "shaft", "inserted" and "hole" without giggling...
|