Quote:
Originally Posted by SuperTom
Is there anything I can do or check?? I will double check all connections pipewise and 02 wise
|
You have a MY17 correct? I see (in EcuTek mind) that the P2270 isn't defined on older ROMs but in ZA1JK00G/01I it is and enabled. It's showing as "O2 Sensor Signal Biased/Stuck Lean B1S2". Without a V3 to compare or know what it's based on I can't comment further. If it was B01C/D then I reckon that's why.
Quote:
Originally Posted by Tuxedo Tony
Also do I need to change any other table when changing just the initial IAM?
|
No
Quote:
Originally Posted by mizzta21
I’m on 91, when I flashed the v4 tune my IAM was set to 1.0 and every time I start my car now my IAM is at .86. Should I change it back down to .7 or just leave it? Isn’t it better to start off with a higher IAM than having to wait til it increases? Thanks in advance.
|
Why not set it to 0.8 then? Lower would be better to start than higher IMO. It doesn't take long to increase unless you're just cruising, in which case it's not going to make much difference anyway.