Quote:
Originally Posted by Joesurf79
Thanks for the insight Mike! If I am understanding correctly, I could probably get away with a 6" spring at this rate in the front? I have a set of 60mm zero-rate Hyperco helpers/locating collars on the workbench as a matter of fact...
Thanks also for the coil bind comments, I haven't seen any evidence of it to this point, so I figured it was unlikely.
|
4 or 5 inch main springs with hypercoil helpers are typically used on CSG spec JRZ setups. With Bumpstops.
If you're "bottomed out" on the spring perch adjustment range to get to the drop you want, then shortening the main spring 1 or 2 inches shouldnt be an issue.