Quote:
Originally Posted by CSG Mike
Typically, for spring rates that high, I would expect to see helpers so that travel is not an issue, and with much shorter springs. I can see how getting to the recommended height is an issue.
... Binding from compressing the spring, with those rates and lengths, should not be possible at all.
|
Thanks for the insight Mike! If I am understanding correctly, I could probably get away with a 6" spring at this rate in the front? I have a set of 60mm zero-rate Hyperco helpers/locating collars on the workbench as a matter of fact...
Thanks also for the coil bind comments, I haven't seen any evidence of it to this point, so I figured it was unlikely.