Quote:
Originally Posted by Clash0901
I've removed the trans mount brackets out of the trans tunnel. I used a dremel with a small cut off wheel to put an "X" into each spot weld, then I used an air hammer to chisel them off. This technique made it very very easy. I mentioned before I tried a $20 set of spot weld drill bits and they were trash.
Now i'm having a little trouble expanding the trans tunnel. I am using a bottle jack but everytime I expand it and loosen the bottle jack, it goes back to shape. Any pointers for this?
|
I used and air chisel with a hammer bit and a 2.5 pound sledgehammer