Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

Rohint75 · 04-15-2018, 08:22 PM

I recently one a free "splitter" on an instagram raffle. I installed it on my front bumber but it covers the holes to attach the liner underneath the car. I am also not able to get the fended flush at the corners and there is a gap between the side panel. My splitter is also somewhat tilted up. Is this all because the bottom liner is not attatched to the bumper correctly? If so whats the best way to attatch the liner to the bumper with the splitter?

04-15-2018, 08:22 PM	#1
Rohint75 Junior Member Join Date: Aug 2017 Drives: 2014 Brz limited SWP Location: Connecticut Posts: 5 Thanks: 0 Thanked 0 Times in 0 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	bumper install with splitter question I recently one a free "splitter" on an instagram raffle. I installed it on my front bumber but it covers the holes to attach the liner underneath the car. I am also not able to get the fended flush at the corners and there is a gap between the side panel. My splitter is also somewhat tilted up. Is this all because the bottom liner is not attatched to the bumper correctly? If so whats the best way to attatch the liner to the bumper with the splitter?