|
So I confirmed that I have spark on all 4 I took out my harness and traced my maf wired all the way to the big connector and nothing still. I still have the maf code but after I reinstalled the harness the car after a while of cranking and hard starting it turns on and idles for about a minute before it dies out. Maf is reading and the maf voltage from the signal with at around 700rpm fluctuates from 1.6-1.7 volts
I was told to check my fuel pressure and on the low side it is good but are there any common issues with high side not having pressure? I need to check again and see what my fuel pressure is at but I was sure I was getting good high side fuel pressure since it’s the only one with a sensor I should see it with scanner or with a log. Have you guys seen any issues with the high side fuel pressure not having enough pressure?
|