More wiring work. I stole the Negative Terminal off my battery and used it to place a terminal in the engine bay. Allows me to keep the battery monitor plug thing on the negative terminal. Not exactly sure if I could delete it, so I would rather keep it.
Pictures are pretty bad as it was cold and dark out as I was finishing up.
Plan is to just bolt the negative terminal on, possibly do the same with the positive terminal with an electrical cut off switch/fuse.
Engine bay positive terminal Finished up. Just need to mount it.
Got the extension harness finished, wrapped, and routed. Need to figure out that Small harness for the fog lights.
Wheel Speed sensor wires exit into frame:
Ignore red wire, but the speed sensor wiring pops out right where it needs to.
Then harness continues behind the headlights. Still needs attached, will do that once I am 100% sure everything works as it should.
Used the nice fabric OEM-esque tape on some of the wiring. I really like the look.
The engine bay is filthy and needs a good deep clean, Hope to do that before engine gets back from Texas Speed. Next is the custom make some wheel covers so the tires quite throwing stuff into the engine bay.