|
I've just swapped out my base headlights for the Monogram/RS lights. Most of the steps you see online are for the JDM headlights which are 8-pin connectors with 7 active leads (pins). The US RS lights are also 8-pin connector but with 6 active leads.
To answer your question, you will re-use (or buy new from Toyota/Subaru) the 6-pin connector from your base headlights.
This is the pin-out for the 6-pin connector that you will re-pin to your RS headlights...
---- TAB ----
| 3 | 2 | 1 |
------------------
| 6 | 5 | 4 |
1 = yellow - high beam +
2 = black (thicc) - headlight gnd
3 = red (thicc) - headlight +
4 = blue - high beam gnd
5 = black - led gnd
6 = white - led +
Alternatively, you can tap the DRL from the resistor (steps found on the JDM headlight install).
|