[JBezugs]

Just installed the shifter, seems like a high quality piece.

I saw that the set screw was installed, however I forgot to check if it was tight... I may pull the car apart again tomorrow to verify, but everything seems fine.

It does rattle a bit above 4000 rpm like everyone is saying, but it isn't too bad and seems to be getting better over time.

EDIT: Been enjoying the shifter over the weekend and on my commute to work today. The rattle is a bit annoying, but I am going to grease up the reverse lockout (though the allen bolt that is on the top of the shifter below the shift knob) and see if that cures the rattle. Looks to have helped with a lot of people who owned the Kartboy.

As a secondary note, I did not reattach the washer when installing the new shifter as they bearing spacers seemed to do that job, but now I have about 1cm of slop in the shifter, so I will add it back.