[NoobBRZ]

So I’m getting really sick of this.

I installed coils a couple of months ago and I had a clunking noise coming from the passenger side. I check it out and find that it’s the endlink nut. So I tighten it and it’s good for 5 days then the noise comes back.

I repeat the process and it’s good for another week

Then it comes back again! So I decide enough is enough and I buy new endlinks with new hardware.

The clunk finally disappears for a month.... until today. It returns and I’m just shocked.... I have to use an Allen key to keep it from spinning while tightening it with a wrench so I can’t really use a torque wrench. The clunk is gone now after tightening it again but if it comes back what exactly can I do? Am I just not tightening it enough? I don’t want to strip the threads by over tightening