View Single Post
Old 03-11-2018, 12:00 AM   #11
Opie
Senior Member
 
Opie's Avatar
 
Join Date: Jun 2012
Drives: 2020 GMC Canyon Denali Diesel
Location: Florida
Posts: 1,997
Thanks: 1,651
Thanked 2,400 Times in 1,026 Posts
Mentioned: 117 Post(s)
Tagged: 0 Thread(s)
Garage
Day 13


Actually completed the timing cover reseal today, what a bear of a job. I can't imagine doing it with the front of the car attached...lol.
New tires arrived
Broke an exhaust stud when removing the exhaust manifold to get the front cover off, hope to get it drilled out and replaced tomorrow.














Found one of the transmission mounting bolts missing and a small bracket for the starter ground. Will get those ordered Monday. Went through all the engine connectors after I found a few loose, and found where one of the miscellaneous brackets that were in the trunk went and got it installed.It's a good thing I can look at the BRZ to see where things go, or how, or what bolts they use.

The used bulkhead harness I ordered was delivered as I was working today, so this evening I started on that. Got the 2nd horn working by repairing 1 wire for it;





Got the oil pressure switch connector replaced;
Attached Images
  

Last edited by Opie; 11-08-2023 at 01:59 PM.
Opie is offline   Reply With Quote
The Following User Says Thank You to Opie For This Useful Post:
dowroa (03-11-2018)