Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

Dee · 03-04-2018, 12:15 PM

So I installed some ST coilovers. Pretty happy, besides some clunking in the rear.
I also installed adjustable SPC lower control arms (rear).

So to make this short, the front alignment was exactly what I wanted. 1.8 camber 0 toe.

However in the rear, the technician said he could get 1.3 camber on the left rear(exactly what I wanted), but on the right rear he could only get down to 2.1 camber. So I had to settle and get 2.1 camber on both sides of the rear

I am not very knowledgable of alignments, I have a little bit of suspension knowledge, but.. why was he able to only get 2.1 on one side while the other he could get 1.3? Is it possible he didn’t know how to adjust the control arm?

P.S. all of the numbers provided are negative camber

03-04-2018, 12:15 PM	#1
Dee Member Join Date: Dec 2016 Drives: 2014 Asphalt FRS Location: Tennessee Posts: 53 Thanks: 8 Thanked 7 Times in 7 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	Alignment question So I installed some ST coilovers. Pretty happy, besides some clunking in the rear. I also installed adjustable SPC lower control arms (rear). So to make this short, the front alignment was exactly what I wanted. 1.8 camber 0 toe. However in the rear, the technician said he could get 1.3 camber on the left rear(exactly what I wanted), but on the right rear he could only get down to 2.1 camber. So I had to settle and get 2.1 camber on both sides of the rear I am not very knowledgable of alignments, I have a little bit of suspension knowledge, but.. why was he able to only get 2.1 on one side while the other he could get 1.3? Is it possible he didn’t know how to adjust the control arm? P.S. all of the numbers provided are negative camber