I ordered some 1/8" and 3/16" wing nut draw clecos with 0 to 1 inch grip to hold the fenders to the body... so now I can start fitting the kit... I'm basically there... finally.
I won't decide on my latching mechanism for the gas cap until I have the fender fitted and secured with the 3/16" draw clecos.
Fiberglassed the stainless steel nuts and washers to make painting the area easier later... it will be easier because I can paint the area without the door being in the way... then install it later.
Only one layer thick since I could not reach the area to reinforce it from behind... I thought I may get away with one layer but nope... So I added 3 layers to the front side. I'm good now.
__________________________________________
Instagram @zeal.eightsix
zeal.eightsix Facebook