I got to work on my install a bit more today. All I did was grind down a couple spots and round out the ends of the opening I posted about earlier. I'm going to use a file to finish some minor adjustments but so far the fitment has been pretty damn good.
Even though I did some homework on this kit... I knew going with a replica was playing with fire but so far this kit looks like it will work out just fine. Anyways...
I rounded out the ends of the opening I cut out previously
Not exactly where the fender will settle in but close. The gap is pretty uniform even before final fitment.
I will add some fiberglass to the tip and reshape it at some point... nothing I'm worried about though.
A bit lifted towards the rear but after I install the hardware it should look fine...
__________________________________________
projekt zeal86 build
zeal.eightsix Facebook
Instagram @zeal.eightsix