We ran into a few bumps which is expected. I was way to optimistic in getting it running last week but we're getting there. Pretty much everything is done and installed:
- Oil pan / crankcase
- Oil filter adapter and remote mount
- All Accessories
- Fuel lines
- A/C lines
- Almost all water lines
We could not find a hose that would work between the filler neck and the thermostat housing and since both are plastic and so close to each other fabrication was not an option. We welded a filler neck on the water jacket pipe but didn't like how it came out. So I finally gave in and ordered an aluminum Koyo filler neck that we can work with.
We still have to make an intake and most likey it will be routed under the headlight.
With that said, the car is getting put back together as the intake pipe and the filler neck are easy to access later. Harness is going in tomorrow, then wiring the CAN BUS module, fuel pump, throttle pedal, cruise control, and A/C.
Pics of it's current state (water jacket will be fixed)
Sent from my Pixel 2 XL using Tapatalk