Had some time over the weekend so I put some more work in on the suspension.
I got the Wisefab rear suspension all mocked up for checking clearances, and to take some measurements.
Due to the knuckle design, my desired ride height, the subframe and diff bushings moving each component from its original place there may be some interference issues with the axles.
Im also taking some measurements to see how much I can push the track width out within the limits of the arms adjustability as well as axle allowance.
Lastly ill also be measuring roll center and seeing where its placement will be in reference to the front and looking for ways to adjust it accordingly to how I want it if needed.
Also in its current state there is 9'' of wheel travel. ID say thats plenty sufficient and ill likely use only around half that, but good to know its there if I need it.
IMG_7785 by
lawrx, on Flickr
IMG_7786 by
lawrx, on Flickr
IMG_7787 by
lawrx, on Flickr
IMG_7788 by
lawrx, on Flickr
IMG_7789 by
lawrx, on Flickr
IMG_7790 by
lawrx, on Flickr
IMG_7791 by
lawrx, on Flickr
IMG_7794 by
lawrx, on Flickr
IMG_2226 by
lawrx, on Flickr
IMG_7800 by
lawrx, on Flickr
Also being a total idiot after looking back at these pictures I mounted the upper control arms upside down. They should be curved down, so as the bend is curving away from the chassis as to provide clearance. Ill swap em over before I take my measurements.