[Ricco]

So tonight, I finally got around to working on the BRZ. I pulled that one caliper, split it, cleaned out the recesses for the seals and reseated everything. Bled that one caliper, and took it for a short (slow) test drive. Had to jump start the BRZ because of the dead battery but the test drive went fine after that. Brake pedal is a little spongy for sure and has more travel than I remember from before so brakes probably need to be bled once more before I call it good.

Overall I'm pretty happy with the result.. I'd like for the front to sit a little lower than it is right now but it is definitely better than before, hope the springs will settle after a little while.







Need to get an alignment and dial in a little negative camber up front.


Also still need to put the White Vinyl stickers on them but I'll give it a few days to check for leaks first. So far so good though.