|
If you have the 2013 with the shitty no screen head unit then you have RCA outputs.
If you have the 2013 W nav unit then you need to
1. Run 4/6/8 Gauge wire from battery terminal to amp.
2. Ground the amp to the ground point in the trunk
3. Tap into the left side and right side channels of the speakers. ( You can do this from the stock amp in the trunk). (check wiring diagram for colour code)
4. Connect the green wire from stock amp (in parallel) to the new sub amp. This is the remote turn on wire
5. Connect the amp to the sub.
6. Make sure your settings in the Headunit is set to external sub (check on the forums how to get to this menu)
Shouldn't have any problems with interference unless you short circuit the amp
|