Quote:
Originally Posted by steve99
Do you have an ecuflash definition in the correct ecuflash directory
How did you edit rom romraider or ecuflash
Did you select brz as the vehicle type ?? In ecuflash before flash
Does car srill start ??
Can you still read the ecu ??
You 100% cannot use boot mode flash method its only if you connsct to the serial interface by soldering an interface directly to ecu.
You must use oem flash method, if ghe oem icon is not active you have not open a valid rom to flash or your tactrix in not plugged into computer or is stuffed usually both read nad write icons will be grey if not tactrix
The error re padfing and unused areas is normail if saving in bin format.
|
Steve, thank you so much for the response! yes the car still started and read fine. Should i not save it in bin format? or is that okay?
I used ecuflash to make the changes in the rom. I'll try editing the .xml like you said and see if that fixes it!
Also is there a way to log the car without using the tactrix SD card setup? I found the OBD logging thread on romraider but the links are bad