Quote:
Originally Posted by s4nd
Thank you very much Steve for the help, yes i had rescale load to 2.5g/rev both on fueling and ignition timing map, i also rescale maf sensor, and sorry, how can i increase port injector fuelling till 30% up?. what table or map should i modify?
cheers
Sand
|
to change the pi/di ratios you would need to later the three pi/di ratio tables for cold/warm/hot
I just guessed on the 30% port
you will need to look at your port and direct injector pulse widths and adjust ratio of port to direct to keep them under 7ms direct and 15 ms port.
Or possible increase size of port injectors if this cannot be done
In addition to rescaling the load axis on tables you also need to adjust the max load limits in the tune else the ecu will just truncate load at a level to low for turbo causing you to run lean.
engine load limiter A and B tables