Quote:
Originally Posted by Jakinit
What camera retention and USB retention did you get? I did a quick install today to see where I'm at and my camera doesn't work. Current thoughts noted below:
1. Steering wheel controls: I went into the setup and it let me set up vol up/down and skip/back. It doesn't seem to register the play, answer or hangup buttons. Did you run into this?
2. Backup camera not currently working. Didn't test it with the engine off, but you mention the steering wheel controls are also the camera?
3. Mic: are you using the included mic? I might try and splice the stock one unless you found an adapter.
4. Need both antenna and USB adapter. Gonna order that now.
5. I need to find where to connect the reverse light. I just grounded the parking break to bypass that but I need to research this one. I only have it a couple hours today.
|
Yes you program the steering wheel controls I didn't program anything other then what the original controls did. Except the button "mode" I use it to bring out Siri. It should give you options to change that tho but I'm not sure if answer/hang up were an option.
The back up camera needs a 12v to 6v if you have the oem camera. You need this part Axxess AX-TOYCAM3 a video out comes from there and a reverse signal should be in pin 2 from that harness. What I did is I tapped into the harness where pin 2 is so I wouldn't have to mess with the oem wires. All the instructions are included. Ax-cam6v is what you need for the voltage drop to 6v.
I did use the oem mic since I hear anything is better than the oem and from my experience is a little better when I make phone calls.
Yes metra 40lx11 is the antenna adapter and pac USB-ty1 I know metra makes one just look to see if they match.
If you buy the ax-toycam3 you can tap in to a reverse signal. Dont forget the 6v step down converter or it will burn out you oem camera.
Sent from my iPhone using Tapatalk