Hi guys. New poster here. I recently aquired a Phantom V2 ESC. But I'm having problems getting the DC motor to engage. Basically by all indications I should be good. I see 28.2 v on the meter. New pc680 batteries. I get all the beeps on startup. The controller fans starts up. Yet nothing from the motor/compressor on either click of the footswitch. Checked and rechecked all connections. I have also checked continuity on every wire that is between two components. Have been in contact with Sojhinn and Fenton, even with their help and suggestions no solution has come to light. Not too far back in this thread member @
eft86 seemed to be exactly where I am. Didn't see where, if he found a solution. I msg him but haven't heard back. Maybe he's moved on? Anyway, I'm hoping one of you good folks will read this and have something further for me to try. I'm at a loss right now. Btw I did try Rob as well, but not heard there either. Thanks for any thoughts you can give.