View Single Post
Old 06-15-2017, 11:18 PM   #1
SorryTires
Member
 
SorryTires's Avatar
 
Join Date: Dec 2016
Drives: 2013 FRS
Location: Regina, Saskatchewan
Posts: 15
Thanks: 10
Thanked 9 Times in 3 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Knocking without knock correction and knock correction without knocking

So I've been getting quite a bit of low rpm/load knock like 20+ knock occurrences in a five minute drive. Almost all below 3000rpm and below 0.4g/rev load. Very few of these knock occurrences cause any knock correction and AM is pinned at 1 the whole time does that just means they are small knocks? is it normal to have so much knock but not have any knock correction?

Also sometimes knock correction happens without a knock signal. Is it normal to have knock correction happen when its not immediately preceded by a knock signal? or is it an error in the log?
SorryTires is offline   Reply With Quote