[DJCarbine]

Push start to "on" then press again without brake input to shut off.... repeat and this time start.

VSC light will be off, cruise control/traction/highbeam indicator light works as well. Pretty sure there needs to be a delay of some sort on one of the ign. or starter lines.

Also figured out the doors locking on engine shutdown. Key sense + not only needs to be connected, but also needs to stay active a second or so after the engine is shut down. Without this delay, the factory security will arm and lock.

Going to see if the advanced keys outputs can provide this delay, if not I am going to get a delay on/off 12v relay to control the keysense.

With the turning on/back off/on again trick fixing the traction/cruise/etc. its pretty much "done". Only need to find the trick in delaying/pre-energizing which line and control it automatically. Not sure what it could be, but perhaps related to ecutek map switching memory. You can choose a map in ecutek via the cruise stalk/tach, but it won't remember it on next start-up.

A trick is to cycle the key to "run" then back off, then start the car normally. It will recall the last map you selected. No clue if related, but its making me think about some sort of delayed start... maybe using the Advanced Keys delay to start option for glowplugs and putting a 500ms delay via a timed relay.

I will update the more I find out