Quote:
Originally Posted by IronMoose
I'm having having an issue with my install. Advanced keys push to start/keyless entry using an idatalink bypass. All functions work but security indicator stays on and doors lock after ignition off. Any suggestions?
|
Just figured this out, the security indication will stay on blinking about the doors will stop locking after you shut the car off with push button
Make sure key sense (Pin 22 BROWN wire of 30 pin D5 connector under dash) has positive signal when running. You can also use a relay to bridge the 2 wires at the ignition switch.
The only other problem I am tracing down is the VSC being on after a push start, and not being able to turn traction control off. I think I need a diode somewhere, as maybe something is using the VSC/Trac circuit as a ground or otherwise using some other wire that has enough ground potential to mess with vsc triggering
::edit
Seems to be slightly related/similar to our issue
http://www.the12volt.com/installbay/...asp?tid=101470
Going to trace the VSC/Trac wiring to see if they use a negative or positive trigger or something else.... something either doesn't have a proper ground or needs to be isolated from the R/S system I feel
Trac system is connected to IG1
::double edit
Beginning to think this is related to the second starter wire