OFT stuck with key on for everything
Hello all, as i just got validated for the forum.
So i had changed the launch control using ROMRaider and i used the correct calibration id and the correct version XML file for my tune and what not. so i saved it uploaded to my OFT then went to flash my car. So it was going very normally however i did notice that at the bottom right of the screen during the green progress bar it did show voltage which was at 12.3 and it made it all the way through with the flash then it said key off in which i did then confirmed then it said key on so i did and then its said key on again.......... then i hit ok again and then it said there was an error writing to the ecu or something of that sort.
I believe for whatever reason it is bricked ive tried many solutions on here that have helped others but cant seem to get my car to start or anything it wont let me try to reflash and wont show anything for realtime data display it says key on for everything and wont pass that if so itll just say error or there was a problem. it will show the info about the ecu such as the vin what file was last used the cal ID and all the other stuff.
Please help kinda need my car for work lol.
All in all is it bricked can it be recovered, i do work at toyota but im no master tech should i have a master tech use techstream to check it out if it is recoverable. if so then i will trailer the FRS over to toyota and have them check it out.
|