|
Weird OFT error during 1st use
So I've searched the forums, and haven't found this exact error yet...
I was marrying the OFT I bought from FT986SpeedFactory, and after reading my ECU, it saves it, then says "Preparing Tuning Files", then after a few seconds, I get what I assume to be an error window that's imposed over the "Preparing Tuning Files" window. It just says "4014ZA1JB00C" with a unlabeled button under it.
I tried waiting and it just stays there, and I've pushed the button. When I push it a new window appears that just says "6014" with a couple progress bars under it.
After that finishes, I get a window that just says "6007", with another unlabeled button. I push it and I get the page that has the "Tuning" etc category icons, but they are no longer labeled, it's just the icons.
When I go into Tuning, the Read and Write icons are grayed out.
All the updates for the tablet were applied through the PC program, and I even unmarried it and tried it again. Then I thought that maybe my battery was weak so I drove the car around the block and still same results.
Is there a way to see if the previous owner put a different tune on the car or something, or am I just screwed? =(
|