Quote:
Originally Posted by allowe
Crap I don't want to replace the op :/. Where did you buy your bolts and what size were they if u don't mind me asking
Sent from my iPhone using Tapatalk
|
You shouldn't need to replace the actual Overpipe. You will need to drill OUT the bolt that is in place (due to heat). As for bolts, 14mm, I do remember going to the local hardware store to grab replacements. I think I was able to pull one out with adding WD40 and an impact gun, the 2nd bolt was being a PIA so we drilled it out.
Make sure to replace all gaskets with quality ones. I got the Grimmspeed pack.
http://www.grimmspeed.com/grimmspeed...st-gasket-set/
__________________
RS*R Sport-I w/custom spring rate / Cusco Front/Rear Sways, Cusco Diff Brace / Cusco Power Brace (Rear/Front/Upper/Lower) / JDL UEL Headers / INVIDIA Q300 Ti / Valenti Revo Tails and rear backup/ EcuTek / Moto-East Flexfuel / Moto-East E85 tune