[Kris86]

Originally Posted by steve99

As Kodename47 said weird it not throwing and CEL codes and CEL light


AFAIK cams should all be at 0 at idle.


If just one is reading 20 then its possible that cam sensor is bad. but should throw code due correlation error.


If its now idling like crap mabe the cam actuator is stuck, but again you would expect cel codes/light.


mabe look through these TSB


11-130-13R : Difficulty Starting, Rough Idle, Cam Position, Misfire
http://www.ft86club.com/forums/attac...1&d=1375302652


02-132-12 : DTCs Relating to the AVCS (Active Valve Control System)
http://www.ft86club.com/forums/attac...0&d=1352490977

I too thought it could be the cam solenoids, so I swapped the intake cam solenoids to see if it would move the problem over to the other head, but the issue is still on the left head. Same exact outcome


I will definitely read through the TSB's... I'm taking any advice that comes to me at this point