03-30-2017, 12:34 PM
|
#8
|
|
Senior Member
Join Date: Jul 2014
Drives: 2020 Hakone
Location: London, Ont
Posts: 69,841
Thanks: 61,656
Thanked 108,295 Times in 46,456 Posts
Mentioned: 2499 Post(s)
Tagged: 50 Thread(s)
|
Quote:
Originally Posted by Schace
Okay so I recently installed an after market steering wheel. I did break the spiral cable but I also replaced it with a new. Well after I got everything back together and did the zero point calibrations I still have a steering angle sensor code. I have disconnected it and measured voltage at the connector I am getting voltage there. Next I measured resistance on the ground wire for that circuit but I'm getting 15 ohms and the circuit should have less then 1 ohm at all times. Please help really stumped on this issue.
Sent from my Pixel XL using Tapatalk
|
Did you use Techstream to calibrate?
__________________
Racecar spelled backwards is Racecar, because Racecar.
|
|
|