Quote:
Originally Posted by Schace
Okay so I recently installed an after market steering wheel. I did break the spiral cable but I also replaced it with a new. Well after I got everything back together and did the zero point calibrations I still have a steering angle sensor code. I have disconnected it and measured voltage at the connector I am getting voltage there. Next I measured resistance on the ground wire for that circuit but I'm getting 15 ohms and the circuit should have less then 1 ohm at all times. Please help really stumped on this issue.
Sent from my Pixel XL using Tapatalk
|
Well, HELLO, Schace and WELCOME to our forum ........
I'm afraid I can't help you but, I'm sure someone will come along soon.
Meanwhile, there is another thread going where the fellow has some sort of steering wheel problem ...... you might want to check it out.
I hope you get it sorted out.....
(have we come a long way ....
, since we would just take the steering wheel off, set the wheels "straight" and put the steering wheel back on the spline (straight) ..... then tighten down the nut and replace the cap. Yep, a 1/2 beer job)
humfrz