hello, guys im hoping this is the correct thread for this, ive read through the first 10 pages solid, and about 75% of the rest, i have a decent grasp on whats going on here, but many of the specifics are a bit confusing...
here is my problem.. i got that damn P0016 CEL/slip light code.. dealership already done there flow chart diagnostics and they replaced the OCV on that cam... code still there, and issue not fixed.. they now want my car for extended time, and will not guarantee that it will be covered.... ive been reading up on it, and my own run down, and everything has been pointing to the ECU.. but they dont want to just flash the with the updated firmware/ROM as they have "procedures" to fallow before getting to that point... and if i want to get them to do that, ima have to either pay out of pocket or spend and extended amount of time with SoA.... but before i go that route i wanted to see if there was something that i could do myself (i usually do all the work on my cars, and this was my first time trying to let the dealership handle it, being a newer car and all..) it would seem that it is quite a direct fix: a cable and an ecu off ebay... ( and some resourceful aid...
so this is where i am now... im ready to get those two items, but before i pull the trigger i want to be sure that i can do what i need to:
my car is a 2014 BRZ MT, USA... i would like to install the second hand ecu (assuming i should be looking for a 2013-2016?) and flash it with the latest OEM ROM for the car that should have the solution for the software glitch that was causing this...
so what im asking is some help with what files do i need to DL to be able to flash the replacement ECU??
im a bit confused in regards to the definitions and base file vs etc? sorry... after a bit i get lost in all the terminology... why i never got into programming...
thank you in advance to whom ever is able to help me with this
