Quote:
Originally Posted by Chimera
I would recommend on the doors and dash just get a component set like the spr-50c or 60c, you'll save heartache in the end. then bridge the amp to them, or not, either way you'll save heartache.
The 3.5s in the dash are technically optional. I have been playing with mine for awhile now, but long story short mixing front drivers will lead to challenges in getting it to sound right. unfortunately good 3way sets are very expensive :<. I have 3.5s but I don't think im going to use them again unless I go full active.
for the rear, 3d printing is an option too, if you know anyone with a printer. there's even a thread somewhere around here where someone posted stl files for 6.5 brackets for the rear. otherwise yea, plywood works, seen other builds with it.
|
So its better just to eliminate the 3.5 in the dash and have the tweeters come off the 6.5 from the doors?
I was just going to use plywood of some kind for the brackets. I wish I knew someone who could 3d print them for me, but then I would need the blue print and I'm bad at finding stuff like that.
I was also considering running the 6x9 in the back off the amp bridged because they have 100 RMS and 50 off the head doesn't seem like it will give me the kind of sound I want. Then I would just rerun the wires... but then it's like what was the point of running everything through the stock harness. To many ways to skin the cat.