Quote:
Originally Posted by 6-Shift
At this point I just want them on the damn car, they've been sitting in my room for over 6 months at this point. But I'm hoping that a full PBM kit is in my future so it's all temporary. I'm worried about rubbing too, especially because I run pretty wide wheels (17x9.5 +30). I'm gonna disconnect my front sway bar too. This is a good event for trial and error since it's basically 9-5 hot lap style.
|
9.5j wheels are definitely too wide for the front on stock fenders with increased angle. I would rub a bit under compression at full lock with 17x9 +15 wheels and 215/40 tires.
And that was just with tie rods. PBM knuckles will give more angle, and more rub.