Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - car in limp mode! cel light along with stablity control popped on

zackegle · 02-24-2017, 07:59 PM

so i was just driving my car along the road as usual slightly aggressive and all of a sudden my check engine light popped on along with the stability control off light and now my car is stuck revving between 2-3k rpms and wont go any higher or lower i assume thats just limp mode... luckily i was near an auto shop so i pulled it in there and they scanned it, p2109 was the only code that came up, which they said was tps sensor related.

has this happened to anyone else before? is it common? and how do i get my car out of limp mode so i can drive it to the dealership?

02-24-2017, 07:59 PM	#1
zackegle Member Join Date: Nov 2016 Drives: 2013 brz limited Location: 84770 Posts: 19 Thanks: 0 Thanked 2 Times in 2 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	car in limp mode! cel light along with stablity control popped on so i was just driving my car along the road as usual slightly aggressive and all of a sudden my check engine light popped on along with the stability control off light and now my car is stuck revving between 2-3k rpms and wont go any higher or lower i assume thats just limp mode... luckily i was near an auto shop so i pulled it in there and they scanned it, p2109 was the only code that came up, which they said was tps sensor related. has this happened to anyone else before? is it common? and how do i get my car out of limp mode so i can drive it to the dealership? Last edited by zackegle; 02-24-2017 at 08:33 PM.