01-27-2017, 01:59 PM
|
#16
|
|
Senior Member
Join Date: Jan 2014
Drives: FRS
Location: SoCal
Posts: 2,086
Thanks: 2,738
Thanked 1,339 Times in 746 Posts
Mentioned: 30 Post(s)
Tagged: 2 Thread(s)
|
Quote:
Originally Posted by DAEMANO
I could see this being useful.
My Velox rear diffuser is too low to get a jack under the diff, and front end is kind of the same. So I jack each side by the pinch welds, and would also like to place the jack stand under the jacking point. This accomplishes that. Only prob is that it doesn't look very low profile-ish and it's actuator arm thing is kinda short-ish.
Can't someone make a lightweight super low profile jack with a long arm THING for us? ARRRRRRRGGHHHHH!!!!!
|
seriously! hahah
|
|
|