Quote:
Originally Posted by dinfern22
Thanks! Are you saying to drill holes on the top and bottom of the licence plate and car? Couldn't I just put the new screw into the existing two holes on top? If so, what size nail/screw should i be looking for?
|
No. Use the existing plate holes. You just want to go through the plastic fastener that the current screws go into so you can lock it with a nut on the inside.
Use whatever size is sufficient to keep the plate snug. I think I used a 10mm hex bolt on mine. My plate holder has a camera on it so it was important for me to secure it properly.