Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - Rewire an AT traction button into MT? Use traction toggle as an accessory?

markitect · 11-16-2016, 01:48 PM

I found that AMP 316836-1 040-3 receptical fits in the connector fine. So with two of those, and a AT switch assembly, you get two new buttons.

Tie Low means the switch connects to Ground not power. So whatever you want to add will have to have a power source(power plug in center consule is probably the cosesst), the fancy thing to add, then go to the wire connector to the back of the buttons, and when the button is pushed it will connect the wire to ground.

11-16-2016, 01:48 PM	#17
markitect Senior Member Join Date: Jun 2011 Drives: Scion FRS Location: Michigan Posts: 216 Thanks: 17 Thanked 59 Times in 39 Posts Mentioned: 1 Post(s) Tagged: 0 Thread(s)	I found that AMP 316836-1 040-3 receptical fits in the connector fine. So with two of those, and a AT switch assembly, you get two new buttons. Tie Low means the switch connects to Ground not power. So whatever you want to add will have to have a power source(power plug in center consule is probably the cosesst), the fancy thing to add, then go to the wire connector to the back of the buttons, and when the button is pushed it will connect the wire to ground. Last edited by markitect; 11-16-2016 at 02:12 PM.