Quote:
Originally Posted by Futaba
Anyway, to make this super clear.
1) The LEDS are not blowing
2) Moving the wires on a working set will not prevent them from failing if they were going to fail to begin with
3) The fault is 100% down to dry solder joints failing
4) Warranty replacement is your best bet, or do what I did if your warranty is expired
|
Thank you so much for this, glad I found your post. You just saved me an awful lot of money on replacements.
If anyone is having issues with condensation I saw there's an actual spec for the gasket seal and how it should look. 1/4" visible, no creases. You may want to dry them out, possibly re-solder any broken connections, and re-install after checking the seal.
Stole this from modbargains.com:
