Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post

nelsonzep · 10-09-2016, 04:26 AM

I have a fiberglass front splitter I made, can also have them done in aluminum

I do not doubt this will pass the "stand test".
Fiberglass is equivalent to aluminum in weight and strength.

Much easier to repair than aluminum and CF for all you riding low.

Also have a rear diffuser made of aluminum available. can make out of any material

Will also accept requests of any composite splitters you want out of CF, Kevlar, Fiberglass or any combination of them. Also offer repairs for composites.

diffuser is $200 + shipping

Splitter is $150 + shipping

10-09-2016, 04:26 AM	#1
nelsonzep Member Join Date: Apr 2015 Drives: 2013 Scion FRS Location: Texas 77532 Posts: 51 Thanks: 0 Thanked 1 Time in 1 Post Mentioned: 0 Post(s) Tagged: 0 Thread(s)	Splitter, Diffuser I have a fiberglass front splitter I made, can also have them done in aluminum I do not doubt this will pass the "stand test". Fiberglass is equivalent to aluminum in weight and strength. Much easier to repair than aluminum and CF for all you riding low. Also have a rear diffuser made of aluminum available. can make out of any material Will also accept requests of any composite splitters you want out of CF, Kevlar, Fiberglass or any combination of them. Also offer repairs for composites. diffuser is $200 + shipping Splitter is $150 + shipping Attached Images Last edited by nelsonzep; 04-12-2017 at 11:05 PM.