Quote:
Originally Posted by Tcoat
From what I understand the Australian police are much more stringent on the compliance of car mods so you may want to check things out locally before going with a loud system. Loud exhaust is one of the easiest ways to attract attention and it may not go well for you.
|
You aren't wrong there! Though I have a single exit blast pipe made of cheap ol' mild steel that sticks out on some retarded angle. No worries at all!
If you want LOUD A/F, the Invidia N1 is the shot. You could get headers and a test pipe and N1, it's a straight through with twin cannons. No resonators or nuffink.
I had Tomei UEL, SME over pipe, catless front pipe, Perrin 2.5" resonated (reduce rasp). When N/A, this set up was noice and loud but surprisingly zero drone. Until you even breathed on the throttle ;D
Without looking at headers, here's a break down of cost from CMA
Invidia N1 - $1190
SME Over Pipe - $285
Hyperflow Racepipe - $249
Is about $1725 - around $1750 AUD shipped. Little bit over cost but if you ring them, they might do you a deal.
http://www.carmodsaustralia.com.au/s...ersal=1&page=1
That would be noice and loud AF for you!!