View Single Post
Old 09-21-2016, 10:23 PM   #1
ajcarson11
Senior Member
 
Join Date: Jun 2015
Drives: 2013 Subaru BRZ Limited (Black)
Location: Indianapolis
Posts: 511
Thanks: 253
Thanked 206 Times in 149 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
Finished SC install -- Can someone look to see if safe to drive/continue logging?

Evening All,

Just finished install of Innovate 210 non-intercooled supercharger with 75mm pulley. Tuned by Mike @ moto-east. 93 pump gas. Car seemed to start fine after tuning, although idle RPM never seemed to dip below ~900 rpm, even after a few minutes.

I took it for my first drive and logged data, staying conservative and listening/feeling for issues. Can someone take a look at this log and let me know if they can see any big red flags? I want to datalog more for Mike, but don't want to be out on the road if there are major issues (i'm new to tuning):

http://datazap.me/u/ajcarson11/first-drive?log=0&data=6

First impressions were confusing -- The car seems unresponsive to throttle input (can hardly rev match on downshifts), and it seems like I have to push down fairly far to get throttle input -- Perhaps this is just due to the tune learning? The car seems down on power as well, but that may be due to throttle input.

Thanks All -- If things look OK then I'll continue driving lightly and gathering data logs.
ajcarson11 is offline   Reply With Quote